We install exterior and interior drainage systems:

SUMP PUMPS
​(Submersible pumps for dewatering)

AVAILABLE IN 1/3 HP OR 1/2 HP

Features and Benefits

• Float-operated, submersible, 2-pole mechanical switch and variable level, long-cycle systems available
• Corrosion-resistant, powder coated epoxy finish
• No sheet metal parts to rust or corrode
• Stainless steel screws, switch arm, guard, and handle
• No screens to clog
• Water-tight, neoprene square ring between motor and pump housing
• Solid, buoyant, polypropylene float
• Oil-filled, hermetically-sealed, automatic reset thermal overload protected motor
• Upper and lower sleeve bearings running in bath of oil
• Entire unit pressure-tested after assembly
• Carbon and ceramic shaft seal
• Maximum temperature for effluent or dewatering: 130 degrees F (54 degrees C)
• Passes 1/2" (13 mm) spherical solids
• 1 1/2" NPT discharge
• On point: 7-1/4" (18 cm)
• Off point: 3" (8 cm)
• Major width: 10-3/32" (26.2 cm)
• Major height: 10-1/16" (25.6 cm)
• Water-tight and dust-tight
• Permanently oiled bearings